From: alex rait (alexrait1_at_nonexisting.hamakor.org.il)
Date: Thu 22 Jul 2004 - 22:34:41 IDT
hello,
I have some wierd problem:
I compiled my kernel 2.6.7 with
SCSI disk support
SCSI generic support
Support for USB
USB device filesystem
EHCI HCD (USB 2.0) support
OHCI HCD support
UHCI HCD (most Intel and VIA) support
USB Mass Storage support
----------------------
everything is loaded so this is the output (without sound and network) of lsmod:
ppp_deflate 4548 -
zlib_deflate 20504 -
zlib_inflate 20644 -
bsd_comp 5124 -
ppp_async 9764 -
ppp_generic 25592 -
slhc 6116 -
uhci_hcd 28980 -
ohci_hcd 18920 -
usb_storage 26596 -
------------------------------------
when I insert my disk on key I can see this in /proc/scsi/scsi:
root_at_alexrait:/dev# cat /proc/scsi/scsi
Attached devices:
Host: scsi1 Channel: 00 Id: 00 Lun: 00
Vendor: Generic Model: Traveling Disk Rev: 1.11
Type: Direct-Access ANSI SCSI revision: 02
-------------------------------------
Then I want to know to what sdX my DOK is assigned so I run dmesg, but here is the
problem, I get this:
scsi0 : SCSI emulation for USB Mass Storage devices
Vendor: Generic Model: Traveling Disk Rev: 1.11
Type: Direct-Access ANSI SCSI revision: 02
USB Mass Storage device found at 3
usb 2-2: USB disconnect, address 3
usb 2-2: new full speed USB device using address 4
scsi1 : SCSI emulation for USB Mass Storage devices
Vendor: Generic Model: Traveling Disk Rev: 1.11
Type: Direct-Access ANSI SCSI revision: 02
USB Mass Storage device found at 4
root_at_alexrait:/dev#
_______________________________________________________________
normally, I would see some entry like:
sda: sda1
(as I understood from others..)
but I don't have it..
any ideas?
thanx for your help
alex R.
_____________________________________________________________
Ïîëó÷èòå áåñïëàòíûé ïî÷òîâûé ýëåêòðîííûé àäðåñ name_at_armenia.ru íà ñàéòå "Àðìåíèÿ Òî÷êà Ðó" - Ãëàâíûé Àðìÿíñêèé Ïîðòàë â ÐóÍåòå.
http://www.armenia.ru
================================To unsubscribe, send mail to linux-il-request_at_linux.org.il with
the word "unsubscribe" in the message body, e.g., run the command
echo unsubscribe | mail linux-il-request_at_linux.org.il
This archive was generated by hypermail 2.1.7 : Thu 22 Jul 2004 - 22:46:21 IDT