Re: assigning a tty to a running proccess.

From: Ehud Karni (ehud_at_nonexisting.hamakor.org.il)
Date: Mon 09 Jan 2006 - 15:32:48 IST

Next message: Diego Iastrubni: "Re: Free replacement for Copernic?"
Previous message: Oded Arbel: "Re: Free replacement for Copernic?"
In reply to: Lior Kesos: "assigning a tty to a running proccess."
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]
Mail actions: [ respond to this message ] [ mail a new topic ]

On Sat, 7 Jan 2006 17:51:58 +0200, Lior Kesos <lior.kesos_at_gmail.com> wrote:
>
> The installation program assumes access to /dev/ttyX while the daemon does
> not have a tty assigned to it.
> Is there a way to assign a tty to a proccess after it has been run?

Use expect, It was built for this, i.e. Run your installation program
by it.

Ehud.

--
 Ehud Karni           Tel: +972-3-7966-561  /"\
 Mivtach - Simon      Fax: +972-3-7966-667  \ /  ASCII Ribbon Campaign
 Insurance agencies   (USA) voice mail and   X   Against   HTML   Mail
 http://www.mvs.co.il  FAX:  1-815-5509341  / \
 GnuPG: 98EA398D <http://www.keyserver.net/>    Better Safe Than Sorry
=================================================================
To unsubscribe, send mail to linux-il-request_at_linux.org.il with
the word "unsubscribe" in the message body, e.g., run the command
echo unsubscribe | mail linux-il-request_at_linux.org.il

Next message: Diego Iastrubni: "Re: Free replacement for Copernic?"
Previous message: Oded Arbel: "Re: Free replacement for Copernic?"
In reply to: Lior Kesos: "assigning a tty to a running proccess."
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]
Mail actions: [ respond to this message ] [ mail a new topic ]

This archive was generated by hypermail 2.1.7 : Mon 09 Jan 2006 - 15:45:02 IST