From: Amichai Rotman (amichai_at_nonexisting.hamakor.org.il)
Date: Sat 10 Jan 2004 - 15:13:59 IST
Hi All,
I apologize in advance for what may be implicated by my question... ;-)
****************
** What I have **
****************
I have a Compaq Presario 2540 EA with the following lspci output:
00:00.0 Host bridge: ATI Technologies Inc: Unknown device cbb2 (rev 02)
00:01.0 PCI bridge: ATI Technologies Inc PCI Bridge [IGP 340M]
00:06.0 Multimedia audio controller: ALi Corporation M5451 PCI AC-Link
Controller Audio Device (rev 02)
00:07.0 ISA bridge: ALi Corporation M1533 PCI to ISA Bridge [Aladdin IV]
00:08.0 Modem: ALi Corporation Intel 537 [M5457 AC-Link Modem]
00:0a.0 CardBus bridge: O2 Micro, Inc. OZ6912 Cardbus Controller
00:0b.0 USB Controller: VIA Technologies, Inc. USB (rev 50)
00:0b.1 USB Controller: VIA Technologies, Inc. USB (rev 50)
00:0b.2 USB Controller: VIA Technologies, Inc. USB 2.0 (rev 51)
00:0c.0 FireWire (IEEE 1394): Texas Instruments TSB43AB21
IEEE-1394a-2000 Controller (PHY/Link)
00:10.0 IDE interface: ALi Corporation M5229 IDE (rev c4)
00:11.0 Bridge: ALi Corporation M7101 PMU
00:12.0 Ethernet controller: National Semiconductor Corporation DP83815
(MacPhyter) Ethernet Controller
01:05.0 VGA compatible controller: ATI Technologies Inc Radeon IGP 340M
Running MDK 9.2 with Kernel 2.4.22-10mdk
******************************
** What I want to fix / change **
******************************
I have the following problems:
[1] No APM / ACPI Support: When removing the 'apm=off acpi=off' from the
'append' line in /etc/lilo.conf the comp freezes after lilo prompt.
[2] No IEEE1394 (FireWire) Support: When trying to load the 'ohci1394
module - comp freezes
[3] No AC-Link Modem Support: Can't find the right driver (ALi? Intel?)
[4] Unknown Device cbb2 ? (first lino on lspci)
[5] No Specific module for Graphics Chip: Runs well with bothe readon
driver from XFree86 and ATI bunduled, but no full screen with FBDEV.
[6] USB: After mounting and writing to a USB-Storage device (DiskOnKey)
comp freezes.
[7] IR Port: Could not find the COM Port it uses. No item in BIOS. Seems
to be only /dev/ttyS0. Will not react to my Palm Pilot IIIxe InfraRed
HotSync. Any one has experience working it? I tried with KPilot
3.1.3-22mdk.
Thanks,
:====================================================:.
Amichai Rotman
Short text-only e-mails: amichai_at_wap.mirs.co.il
UIN#: 6401746
Registered Linux User#: 201192
=================================================================
To unsubscribe, send mail to linux-il-request_at_linux.org.il with
the word "unsubscribe" in the message body, e.g., run the command
echo unsubscribe | mail linux-il-request_at_linux.org.il
This archive was generated by hypermail 2.1.7 : Sat 10 Jan 2004 - 15:24:47 IST